H&R SS leaning to the rear
Hey guys, I got some Koni Yellows for my 03 Mach last year. Picked up my H&R Supersport springs with MM Caster/Camber plates. on a flat surface it almost looks as if the rear sits lower than the front. I'm running poly isos front and rear. Anyone have a similar problem or know how to fix said issue?
|
Re: H&R SS leaning to the rear
EAYou can try removing the front isos and just leave the rears in
Or you can play with the clocking of the rear springs (where the tail points |
Re: H&R SS leaning to the rear
Or by some MM LCA adjustables & raise the rear a bit.
|
Re: H&R SS leaning to the rear
I know most don't, but I prefer a slight negative rake...I say leave it :secret:
|
Re: H&R SS leaning to the rear
I know when I ran polys in the front they were pretty thick and seemed to lift the front, I quickly removed them.
|
All times are GMT -4. The time now is 09:37 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
(c) 2002-2013 Mach1Registry.com