alignment done, thoughts
Got alignment done today here is what we got. Do I need the camber bolt?
[IMG]http://i1322.photobucket.com/albums/...pspinveqme.jpg[/IMG] ASh |
Re: alignment done, thoughts
you prolly need caster camber plates to move the shock out to fix the camber you have. the way its setup it will drive straight but the tires will wear on the inside edge.
|
Re: alignment done, thoughts
Bad article once I went back and read it again.
Nevermind. |
Re: alignment done, thoughts
Quote:
but I guess it will be happening ASh |
Re: alignment done, thoughts
Quote:
ASh |
Re: alignment done, thoughts
I posted an article, but when I went back and read it again it was bad info...
Gib |
Re: alignment done, thoughts
Is that the caster you were shooting for? Looks like it was done to stick spec, I know with my MM K member, dude on phone told me 6, also I have total toe at .30, is the difference the tear of your Cobra? Also before plates, go to Advance and get camber bolts for the 2 bottom nuts on the struts, the shaft near the head is oblong so as you turn them you can increase camber below, and if you go over back off up top or vice versa, may be worth looking at.
|
Re: alignment done, thoughts
Quote:
:orange: ASh |
Re: alignment done, thoughts
Quote:
ASh |
Re: alignment done, thoughts
Well i'm going to just try the Camber bolt and go from there,
should be placing a order soon for them and see what happens ASh |
All times are GMT -4. The time now is 03:53 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
(c) 2002-2013 Mach1Registry.com