What size pulley & belt size for Procharger D-1SC?
My Mach 1 currently has OEM rotating assembly. What pulley/belt size to keep power around 450 rwhp? Current supporting mods: Accufab throttle body, Ford 60 lbs injectors, DW300 fuel pump (340 lph), Borla Stingers, MRT O/R H-pipe, SCT BA3000 MAF, Ford 3.73 gears, DSS driveshaft, Torsen diff, and Moser 31 spline axles. Not planning on building the bottom end and installing blower cams until 12-18 months from now.
|
Re: What size pulley & belt size for Procharger D-1SC?
4" pulley and k061098 belt should be close. Might need a BAP, but everything else you listed should be fine.
|
Re: What size pulley & belt size for Procharger D-1SC?
a 4 or 4.1 is gonna the biggest that will fit and even then might have to clearance the corner of the valve cover. Limiting it to only 450 will probably require a very low timing tune and/or keep rpms down
|
Re: What size pulley & belt size for Procharger D-1SC?
Quote:
|
Re: What size pulley & belt size for Procharger D-1SC?
Quote:
|
Re: What size pulley & belt size for Procharger D-1SC?
I ran a 4.1" pulley on my P1 and I don't think I could even fit a piece of paper between the valve cover and the pulley, but it did not rub. My 4.1 put down 458 to the tires on a Mustang Dyno.
As for fuel, I believe I ran the Cobra fuel system and 48# injectors. |
Re: What size pulley & belt size for Procharger D-1SC?
could notch the valve cover if he needs to, did that on mine.
Just incase. ASh |
Re: What size pulley & belt size for Procharger D-1SC?
Quote:
ASh |
All times are GMT -4. The time now is 11:06 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
(c) 2002-2013 Mach1Registry.com