- Thinking of Power...
- Blower Package on Ebay
- '05/'06 GT vs. '03/'04 Mach 1...mod?
- Procharger idler pulley wearing out
- NX Kit
- My nitrous install has begun...
- Correct NX Jets for 50 & 100-shots???
- Forced Induction Guys
- Nitrous / Gear and tire size choice.
- 150 shot going in...
- Need power!
- D1-sc Running Lean Up top
- Any Ideas on where to hide nitrous bottle?
- Any whipple machs???
- Nitrous Filling stations???
- Adding a KB, Tranny and rear end questions
- 660rwhp - F1A [Video]
- KB Question, Cobra IC?
- Procharger--Blow Thru or Draw Thru?
- Hey guys! In the middle of my Procharger install and have a few questions.
- 2 core to 3 core intercooler conversion ?s
- For all you boost and fuel pressure guys.
- SWITCHED 12V source(s)???
- Popular fuel pump thread
- Untuned 9psi Intercooled 1.7L Kenne Bell Mach 1 Start Up
- Can I turn the car on after Procharger install untuned??
- procharger ??
- Help with fuel pump..255 lph guys in here!
- Wet Shot or Dry Shot ????
- SCT "Big Air" MAF w/ ProCharger questions:
- 03 or 04 cobra motor
- Look In Here!!
- Where To Mount Nitrous Bottle/Switches?
- JLT with ProCharger
- where to tap for fuel
- forged internals ?
- For those with nitrous, what intake pipe are you using?
- Boost Gagues
- What would be more reliable with a S/C? 5.0L Stroker or 5.3 Big Bore?
- Stock fuel system with 10 lb Procharger?
- Nitrous install is complete - Mach is now in tuner's hands...
- Idea's on where I can get a rubber tube.
- Add spray and a tune?????
- Cobra vs. KB setup
- Good source for "Plug-Reading" Info & Pics???
- Spark Plug "Prep"???
- Louder Surge valve or BOV for Procharger?
- Last-Minute Nitrous "Checklist"???
- Lost boost some where ???
- Some swap questions
- Best price on Cobra tank and dual pumps?
- PROCHARGER help please
- D1SC making 8psi?
- What rearend gear are you running with your blower?
- Has anyone had issue's with a Eaton Diff.
- Mach 1 with Eaton'ed Again pleaze!
- Quick vid I made of my Procharged Mach 1!
- Calibration number?
- gears and blower
- Need some information
- focus pump w/eaton blower conversion?
- Thinking about NITROUS...
- Nitrous Dyno Results...
- Best NPT/Pipe Thread Sealant???
- How much power you think I'm making?
- Help on belt routing
- kenne bell mach dyno run at carlisle
- No Nitrous Runs Yesterday...
- How much timing up top?
- Fuel Rail Pressure @ Idle?
- Time To Hit The Bottle...NO2 Here I Come!
- need help putting a cobra eaton on a gt
- Need help
- How long does it take??
- fuel pump basket mod?
- Err...pully squeeking.
- 3.6 to a 3.3 pulley..how much more boost??
- 9 lbs and stock bottom end??
- Procharger Video
- You know what I'm sick of:
- IAT's with Procharger?
- Kenne Bell Mach drive by's!!!
- Pro Turbo Systems kit - disappointing service
- thinking about the procharger race bypass?
- F1A and a 3.6 pulley, anyone????
- Another Prochaged mach
- Mach 1 SC input
- Source for longer purge tube???
- Blow by??
- 03 Cobra Blower, would that work on our cars?
- Power Pipe....yea or nea???
- What should I do with $2000.00?
- 8 rib conversion still spitting belts.....
- Problems after Blower install
- 2-step limiter w/ nitrous activation diagram
- Cobra Tank Swap Tip
- Cobra intercooler water pump?
- What is the most boost you are running on the stock compression...
- about how much power is safe
- Procharger guys, did you remove your thermostat?