- adjustable clutch cable vs firewall adjuster
- 3rd Gear
- NGK TR55 Vpower plugs?
- Doubling a PHP spacer
- better cold air kit steeda or C&L
- Mach Would Not Crank
- What's the normal idle RPM's?
- Front wheel bearings
- Tremec 3650, noises when cold
- Automatic Trans Mods For Mach's
- what u think
- Huge Props to K&N!!!
- Car Shutting off during idle
- Dyno Tuned And Have A Problem
- Stock fuel injectors??
- A couple of questions??
- Stalling With PHP Airbox
- What Type of Head Studs?
- Mbr
- Forced to beef up the 8.8
- Where to buy stock valvetrain parts?
- Help with ET Analysis...
- valve covers
- Which tranny??
- pulley tq specs
- Question About Headers/cold Air
- local shop messed up gears 3 times
- shop screws up gear install for 3rd time going on lucky #4
- Intake spacers
- So what kinds of noises are these engines supposed to make?
- Air Deflector in the Shaker
- Hurst shifter problem...help needed
- replacing the clutch
- Rounded Main Bolt Removal???
- holy shreded belt batman!
- Teksid 4.6 32V motor for sale on another forum
- 03/04 cobra flywheel and stock clutch?
- K&N Cold Air Working With Steeda 2pt STB
- cam ladders
- Time for a clutch any suggestions
- stall help
- Pressure Plate Bolts ?
- oil pump
- weak link in engine
- Broken Input Shaft?
- Alum Driveshaft Installed!!!!!
- Attention C&L Guys
- looking into getting an eletric water pump ,got a question?
- recalibrate my speedometer
- Stock HP and with mods...
- Everybody With PHP Intake Spacer Please Vote
- Painted rear-ends???
- Safety loop install
- Fidanza Cam gears
- Second gear....sigh....
- When should plugs be changed?
- Stall
- 31 spline rearend
- Stock Heads Question?
- Accufab Throttle Bodies
- Cam lobes hit cap support
- Traction control
- anybody using a TB spacer???
- Engine Stall
- Spedometer doesn't work!
- slow idle down
- Guys with 4.56's. How do you like them?
- Strange noise
- PHP spacer question...
- ATTN: GEARHEADS - 2V GT Motor Mod Question
- Atf
- powershiftin help
- intake spacer question
- Carnage Pics from Bowling Green, KY
- Clutch And 60ft
- Electric water pump question
- irs
- Found the Accufab hanging idle problem
- Need air filter info w/ C&L...
- WTF... my ram clutch exploded?? during traffic accleration???
- Best Shifter
- How Much HP can a P1SC put out?
- TR-3650 - 26 Spline Input Shaft ???'s
- Took the Mach in AGAIN for the tick
- Huge Engine Problem..........?????
- Need a tune with these mods?
- What all is needed, and how involved.....
- new trans, what should i get
- sensor
- A/C clutch slipping after 8 rib swap.
- Got My Car Back =D
- fiore adjuster& quadrant
- OK so what does this mean
- 03 Cobra Pumps vs. Ford GT Pumps - An electrical comparison
- 1-2 & 2-3 Gear Lockout and clunk!
- need help quick!!
- 1-2 Crunch, still :(
- Aviator intake
- 5th Gear Noise
- Manual Transmission Cooler?